The new Uniden UBC75XLT is a compact 300 channel handheld scanner with 5 / 8.33 / 12.5 KHz steps and fast scanning rate of 90 channels per second. Ideal for listening to the communciation from Civil Air Control, Boats, truckers operating on CB radio, Ham Radio/Amateur Operators, Sporting events, Churches and Mosques etc.
Main features include 300 memory programmable channels, close call RF capture with Do-Not-Disturb, automatic close call detection and tune into nearby transmission, 10 pre-programmed service searches, 10 custom search ranges, channel priority with Do-Not-Disturb, temporary lockout, PC programming, battery save and low battery alert, scan/search delay/resume options, quick and turbo search facility, triple conversation circuit, key confirmation tones, three power options and many more. This scanner also has a built-in USB charger, which enables you to charge it by using your i-Phone or other smart phone 3 pin USB adaptor or if you are on the road, you can also charge it by using a USB adaptor, which plugs into the cigarette lighter socket of your vehicle. (USB cable comes with the scanner in the box). Please see accessories tab option of this product. Programming software for this scanner is also available, please see our product code PRG-ARC75 or see accessories tab. The box includes UBC75XLT scanner, antenna with BNC connector, belt clip, USB cable, hand strap and owner's instructions manual Technical Specifications: Channels: 300 Channels Frequency Range: 25 - 512MHz Frequency Steps: 5/6.25/8.33/10/12.5 Banks: 10 (30 channels each) Sensitivity: SINAD 12dB, Nominal Operating Temperature: Normal: -20°C to +60°C Close Call: -10°C to +50°C Scan Rate: 90 channels per second Search Rate: Normal: 90 steps per second Hyper: 270 steps per second Priority Sampling: 2 seconds Scan Delay: 2 seconds IF Rejection (at 453.25MHz): 80dB Internal Speaker: 24 ohm, 0.8W Max Audio Output: Internal Speaker: 360mW nominal (24ohm) Headphone (L-ch): 4mW nominal (32ohm) Current Drain: Squelched: 120mA Full Output: 280mA Power Requirements: 2 x AA Alkaline Batteries (3VDC) or 2 x AA Rechargeable Ni-MH Batteries (2.4V DC) or Connect to PC with USB cable (5.0V DC 500mA) Antenna: 50 ohms (Impedance) External Jacks: Antenna Jack (BNC Type) Phone Jack (3.5mm) USB Jack (5pin Mini USB B Type) Dimensions: 67mm(W) x 32.7mm(D) x 115mm(H) Weight: 175g (without antenna and battery)